Supply wind models corn peeling machine homemade corn peeling machine corn peeling machine offer McKinnon machinery 

 Corn peeling machine operation: 
 1, fixed motors, two sheaves in the same line, connect the power supply, you must connect the ground, well anyway, turn after 5 minutes idling down to check various parts of the screw is loose, the Triangle of tightness, lubrication The parts are hot, as well as two new compression, if exception should be adjusted. 
 2, crude rubber roller with fine rubber roller with no gap, crude rubber roller to rely on the adjustment of the spring pressure, through the role of the rocker arm tightly pressed on the fine roll, the greater the spring pitch the smaller the pressure, mass pressure to crude rubber roller Conversely the greater the spring pitch adjustment requires about 2-4mm, which is the key to influencing the stripping effect of the machine factory has been adjusted to use the location within the user should be based on actual conditions pay attention to the adjustment. 
 Corn peeling machine before the job is on the cover parts of the shield of the transmission operations must be performed in the safety provisions, strictly follow the rules work, without any negligence matters requiring special attention are as follows: 
 The ⑴ ear must be parallel to the uniform feeding, not up and down overlapping feeding erected ear in the course of their work, should increase the feed rate of new feeding ear squeeze down. 
 ⑵ machine bract and machine consequences spike must promptly clean up the machine, otherwise easily lead to the bract wrapped or blockage of exports. 
 (3) staff shall not put his hand into the feed inlet baffle, to prevent accidents. 
 ⑷ card roll around the roll must be shut down after processing, shall deal with in the rotation. 
 ⑸ prohibited the feeding of brick, stone, wood and other hard objects. 
 Note the use of corn peeling machine: 
 First, in the purchase of corn peeling machine, you should select the the formalities dealer. Corn peeling machine, brand, manufacturer name, site and factory certification label should be complete, security guards, and a detailed manual, credit card or the "Three Guarantees" service vouchers and promotional licensing, and other. At the same time, do not forget to request an invoice, find the basis for future problems. 



 Four-axis corn peeling machine 



 Corn peeling machine, belonging to corn processing machinery. Its main body, the body has a feed inlet, power seat connected to the body, the motor is installed in the power seat, the driving shaft installed in the bearing seat, the driving shaft connected through the belt and motor driving shaft has spiral strips and rubber nails, driving shaft through a gear and drive shaft to match more with raised rubber wheel on the drive shaft. Driving shaft at both ends of the bearing is not the same horizontal plane. Equipped with multiple rubber wheel driving shaft with spiral strips and rubber nails, drive shafts, drive shafts and drive shaft with each other evenly peeling device has entered inside the ear, assigned to the two pairs of relative rotation of the stripping axis, and the ear itself rotating smoothly forward, the move, a special peeling claw ripped the bract, and live in the instant axis of rotation Rolling bract to the drop-down, and the completion stripped the purpose. Ergonomics from 0.85 to 1.25 / h, stripping the net rate of 80% to 95% broken rate of less than 1% loss rate of less than 2%. Corn peeling operation can be completed to replace manual operations, improve work efficiency. 



 Phone: 18631965453 
 QQ: 1639023192 
 0319 - 6,320,282