Supply of corn peeling machine corn peeling machine how much corn peeling machine, the working principle McKinnon machinery 

 Corn peeling machine, belonging to corn processing machinery. Its main body, the body has a feed inlet, power seat connected to the body, the motor is installed in the power seat, the driving shaft installed in the bearing seat, the driving shaft connected through the belt and motor driving shaft has spiral strips and rubber nails, driving shaft through a gear and drive shaft to match more with raised rubber wheel on the drive shaft. Driving shaft at both ends of the bearing is not the same horizontal plane. Equipped with multiple rubber wheel driving shaft with spiral strips and rubber nails, drive shafts, drive shafts and drive shaft with each other evenly peeling device has entered inside the ear, assigned to the two pairs of relative rotation of the stripping axis, and the ear itself rotating smoothly forward, the move, a special peeling claw ripped the bract, and live in the instant axis of rotation Rolling bract to the drop-down, and the completion stripped the purpose. Ergonomics from 0.85 to 1.25 / h, stripping the net rate of 80% to 95% broken rate of less than 1% loss rate of less than 2%. Corn peeling operation can be completed to replace manual operations, improve work efficiency. 


 Specific operating a first machine on a flat, solid ground, the machine must sound level of the ground. 

 2, check the various parts of the bolt. If loose, must be re-fastening. 

 3, check the vulnerable parts. If damaged, must be in accordance with the manufacturers specifications to be replaced, allowing the machine to sick job. 

 4, check the circuit line is safety, prohibition of work in case of leakage. 

 5, power mount. The size of the power must match with the machine, not to arbitrarily selected. 

 6, adjusting the belt. Belt tightness is appropriate over the pine bark with slippery caused by speed less than affect or even cause the machine to plug too tight, causing a fever affect the service life of motor overloading fever and machine bearings. Hand struck the pulley, make sure that each transmission system in a normal state. Jog machine to confirm the correct direction of rotation, the boot empty running 5 ~ 10min, there should be no abnormal vibration and noise (in this case, all personnel shall be away from the machine), make sure everything is normal and correct, you should try and take off, according to the threshing quality targeted regulation, to achieve satisfactory results, the normal operating