Supply of new corn peeling machine corn pictures corn peeling machine peeling machine accessories McKinnon machinery 

 Corn peeling machine, belonging to corn processing machinery. Its main body, the body has a feed inlet, power seat connected to the body, the motor is installed in the power seat, the driving shaft installed in the bearing seat, the driving shaft connected through the belt and motor driving shaft has spiral strips and rubber nails, driving shaft through a gear and drive shaft to match more with raised rubber wheel on the drive shaft. Driving shaft at both ends of the bearing is not the same horizontal plane. Equipped with multiple rubber wheel driving shaft with spiral strips and rubber nails, drive shafts, drive shafts and drive shaft with each other evenly peeling device has entered inside the ear, assigned to the two pairs of relative rotation of the stripping axis, and the ear itself rotating smoothly forward, the move, a special peeling claw ripped the bract, and live in the instant axis of rotation Rolling bract to the drop-down, and the completion stripped the purpose. Ergonomics from 0.85 to 1.25 / h, stripping the net rate of 80% to 95% broken rate of less than 1% loss rate of less than 2%. Corn peeling operation can be completed to replace manual operations, improve work efficiency. 


 Pre-operational check: 

 1, check the various components should be in good condition, the fault should be immediately removed. Check all parts of the bolt, if loosening must be tightened. 

 2, removal of residues in grain and debris after the previous job, the machine a comprehensive inspection, bearings and other rotating parts of each class should be filled with oil. 

 Operations after the overhaul: 

 1, the frequency of operations to check the various parts of the bolts fastening, and machine maintenance. Quarterly operating after should conduct a comprehensive inspection and, if damaged or badly worn parts should be repaired or replaced to ensure that the next threshing season. 

 Machine maintenance and repair, it should be, outside clean, place in dry and ventilated room. Machine should not be placed directly on the ground to avoid damp. If the paint off should make up brush, no paint components shall be coated with anti-rust oil. 

 3, on a regular basis to all bearings filling oil, most of the new machine the first 10 days filling time, filling time after each month. Bearing replacement by professional service personnel, so as not to affect the quality of the overall assembly.